Camera board, Removing the camera board – Dell Inspiron 11z (1110, Mid 2009) User Manual
Page 9
Back to Contents Page
Camera Board
Dell™ Inspiron™ 11 Service Manual
Removing the Camera Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Disconnect the speaker cable from the speaker cable connector on the I/O board (see
Removing the Speakers
).
6.
Remove the hard drive (see
Removing the Hard Drive
).
7.
Remove the memory module (see
Removing the Memory Module
).
8.
Remove the palm rest bracket (see
Removing the Palm Rest Bracket
).
9.
Remove the display assembly (see
Removing the Display Assembly
).
10.
Remove the hinge caps (see
Removing the Hinge Caps
).
11.
Remove the display bezel (see
Removing the Display Bezel
).
12.
Remove the display panel (see
Removing the Display Panel
).
13.
Disconnect the camera cable from the connector on the camera board.
14.
Lift the camera board off the display back cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
camera cable connector
2
camera board