Reporting bugs, Support – Dell Intel PRO Family of Adapters User Manual
Page 38
This is the common configuration file for the fcoe system service. This file will be read by the
/etc/init.d/fcoe script, the etc/fcoe/scripts/fcoeplumb script, and the fcoemon daemon. The default
options in this file are:
DEBUG="yes" and BUSE_SYSLOG="yes".
The former is used to enable (select yes) or disable (select no) debugging messages of fcoemon, the
fcoe service script, and the fcoeplumb script. The latter is to indicate if the log messages of
fcoemon, the fcoe service script, and the fcoeplumb script are to be output to the system log. Use
editor to set the desired yes/no values.
/etc/fcoe/cfg-ethX
There is one of these files for each Ethernet interface ethX found in the output of cat /proc/net/dev
at the time of installation. The file will be read by the /etc/init.d/fcoe script and the fcoemon
daemon. The default options in this file are:
FCOE_ENABLE="no" and DCB_REQUIRED="yes". The former is used to enable (select yes) or disable
(select no) the FCoE service at the ethX port. The latter is to indicate if the DCB service is required
(select yes) or not required (select no) at the ethX port. If the former is set to no, the latter is
ignored. The selection of the settings should match the settings of the FCoE switch port connected
to the local Ethernet ethX port. Use editor to set the desired yes/no values for the ethX interfaces.
/etc/init.d/fcoe
This is the fcoe system service shell script. This script is invoked by the init process or by the service
command.
/sbin/fcoemon
This is the fcoemon daemon only invoked by the fcoe system service script.
/sbin/fcoeadm
This is the program used by the fcoe system service to create or destroy FCoE interfaces.
Reporting Bugs
Support
. There are resources available for both developers and users at that
site.
.