Dell XPS One 2720 (Mid 2013) - Manual (Page 73)

Replacing the Antenna Modules | 73
Replacing the Antenna Modules
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the antenna modules with the alignment posts on the display bezel and
adhere the antenna modules to the display bezel.
2 Route the antenna cables through their routing guides and connect the
antenna cables to the wireless mini-card.
Postrequisites
1 Replace the inner frame. See "Replacing the Inner Frame" on page 50.
2 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 32.
3 Replace the I/O panel. See "Replacing the I/O Panel" on page 41.
4 Replace the stand. See "Replacing the Stand" on page 22.
5 Replace the trim cover. See "Replacing the Trim Cover" on page 20.
6 Replace the back cover. See "Replacing the Back Cover" on page 18.
7 Follow the instructions in "After Working Inside Your Computer" on page 13.
OM_Book.book Page 73 Wednesday, April 3, 2013 1:39 PM