Dell PowerVault DP500 - Manual (Page 32)

Installing the Cooling Shroud
1. Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3 -10 .
2. Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place.
Fan Brackets
Removing the Fan Bracket
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the System .
3. Remove the cooling shroud. See Removing the Cooling Shroud .
4. Remove the SAS controller daughter card. See Removing a SAS Controller Daughter Card
5. Remove the fans from the fan bracket. See Removing a System Fan .
6. Remove the fan bracket from the system:
a. Press down on the release latch on the left side of the fan bracket. See Figure 3 -11 .
If the bracket does not disengage completely, push down slightly on the bracket when releasing the latch.
b. Rotate the left side of the bracket upward, releasing the plastic clip from its slot in the power supply cage.
c. Draw the bracket out of the system.
Figure 3-11. Removing and Installing the Fan Bracket
1 shroud pivots (2) 2 cooling shroud
3 release latch 4 shroud hinges (2)
5 fan bracket
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.