Dell PowerVault DP500 - Manual (Page 56)

Installing the Control Panel Assembly
1. Insert the display module into the chassis cutout and secure with the two Torx screws.
2. Affix the display module label to the display module.
3. Install the control panel board in the system chassis and secure with the three Phillips screws. See Figure 3 -34 .
4. Connect the display module cable to the control panel board. See Figure 3 -34 .
5. Connect the control panel cable to the control panel board. See Figure 3 -34 .
6. Close the system. See Closing the System .
7. Reconnect the system to the power source and turn on the system and attached peripherals.
8. If applicable, install the bezel.
System Board (Service-only Procedure)
Removing the System Board
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the System
3. If applicable, remove any expansion cards. See Installing an Expansion Card
4. Remove the expansion-card cage. See Removing the Expansion-Card Cage
5. Remove the cooling shroud. See Removing the Cooling Shroud .
6. Remove the fans. See Removing a System Fan .
7. Remove the fan bracket. See Removing the Fan Bracket
8. If applicable, remove the RAC card. See Installing a RAC Card
9. Remove the memory modules. See Removing Memory Modules .
10. Remove the heatsink(s) and microprocessor(s). See Removing a Processor .
11. Remove the TOE key, if present. See Figure 6 -2 for the location of the TOE key.
12. Remove the sideplane. See Removing the Sideplane Board .
1 display module label 2 display module securing screws (2)
3 display module 4 display module cable
5 control panel cable 6 control panel circuit board
7 control-panel circuit board securing screws (3)
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
CAUTION: The DIMMs are hot to the touch for some time after the system has been powered down. Allow time for the DIMMs to cool before
handling them. Handle the DIMMs by the card edges and avoid touching the DIMM components.
NOTE: While removing the memory modules, record the memory module socket locations to ensure proper installation.