Scsi tape drive – Dell PowerVault DP500 User Manual
Page 42
Installing the Diskette Drive Into the Drive Carrier
1.
Align the back of the diskette drive with the back of the carrier.
2.
Add the shim to the drive.
3.
Gently push the drive into the carrier until it pops in securely. See
.
SCSI Tape Drive
This section describes how to configure and install an internal SCSI tape drive.
Removing and Installing an Internal SCSI Tape Drive
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2.
Remove the tape drive carrier from the media bay by squeezing the release tabs on either side of the carrier down and forward, sliding the carrier
gently from the bay. See
.
Figure 3-23. Removing and Installing the Tape Drive Carrier
1
diskette drive tray
2
shim
3
diskette drive
4
diskette drive release tabs (2)
NOTE:
Installing a SCSI tape drive requires an optional SCSI controller card.
NOTICE:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product Information Guide.