Dell Dimension 1100/B110 - Manual (Page 27)

Solving Problems
27
Mouse Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
I F YOU EXPERIENCE OTHER MEMORY PROBLEMS —
• Reseat the memory modules (see page 55) to ensure that your computer is successfully communicating
with the memory.
• Ensure that you are following the memory installation guidelines (see page 55).
• Your Dell Dimension™ computer supports DDR memory. For additional information on the type of
memory supported by your computer, see "Memory" on page 79.
• Run the Dell Diagnostics (see page 38).
C LEAN THE MOUSE — See "Cleaning Your Computer" on page 91 for instructions on cleaning the
mouse.
C HECK THE MOUSE CABLE —
1 Check the cable connector for bent or broken pins and for damaged or frayed cables. Straighten bent
pins.
2 Remove mouse extension cables, if used, and connect the mouse directly to the computer.
3 Shut down the computer (see page 47), reconnect the mouse cable as shown on the setup diagram for
your computer, and then restart the computer.
R ESTART THE COMPUTER —
1 Simultaneously press <Ctrl><Esc> to display the Start menu.
2 Type u , press the keyboard arrow keys to highlight Shut down or Turn Off, and then press <Enter>.
3 After the computer turns off, reconnect the mouse cable as shown on the on the setup diagram for your
computer.
4 Start the computer.
T EST THE MOUSE — Connect a properly working mouse to the computer, and try using the mouse.
C HECK THE MOUSE SETTINGS —
1 Click the Start button, click Control Panel, and then click Printers and Other Hardware.
2 Click Mouse.
3 Try adjusting the settings.