Dell Dimension 1100/B110 - Manual (Page 68)

68
Removing and Installing Parts
Installing a Hard Drive
1 Unpack the replacement hard drive, and prepare it for installation.
2 Check the documentation for the drive to verify that it is configured for your computer.
3 Remove the hard drive bracket (see page 66).
4 Attach the hard drive to the hard drive bracket:
a Place the small bracket tabs into the drive screw holes on one side of the drive.
b Gently swing the drive toward the bracket and align the two screw holes on the other side of the
drive with the screw holes on the bracket.
c Insert and tighten the two screws that secures the hard drive to the hard drive bracket.
5 Install the hard drive bracket containing the hard drive:
a Insert the two bracket tabs into the two bracket securing slots inside the computer.
b Rotate the bracket toward the front panel and align the bracket screw hole with the screw hole in
the chassis.
c Replace the two screws that secure the bracket to the computer.
drive bracket
hard drive
bracket screws (2)
bracket tabs (2)