Dell Dimension 1100/B110 - Manual (Page 78)

78
Removing and Installing Parts
6 Replace the computer cover (see page 78).
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the
computer.
7 Connect your computer and devices to electrical outlets, and turn them on.
8 Enter system setup (see page 83) and restore the settings you recorded in step 1.
9 Properly dispose of the old battery (see the "Battery Disposal" section of your Product Information
Guide).
Replacing the Computer Cover
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
1 Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2 Ensure that no tools or extra parts are left inside the computer.
3 Place the cover on the computer.
4 Slide the cover towards the front of the computer until it fits completely into place.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
5 Connect your computer and devices to electrical outlets, and turn them on.
battery socket
battery
tab