Dell PowerEdge 2970 - Manual (Page 103)

Installing System Components
103
Figure 3-30. Replacing the Left Riser Board
Installing the Left Riser Board
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Place the riser board in the expansion-card cage so that the six securing tabs are fully inserted through
the tab slots and notches on the riser board. See Figure 3-30.
2 Slide the riser board toward the expansion card openings until you feel the riser-board release pin snap
into place.
3 Replace the expansion-card cage. See "Replacing the Expansion-Card Cage" on page 79.
4 Install all expansion cards in the expansion-card slots. See "Installing an Expansion Card" on page 72.
5 Close the system. See "Closing the System" on page 56.
1 riser release pin 2 expansion-card rail 3 expansion-card cage
4 riser securing tabs (6) 5 tab slots (3) 6 tab notches (3)
2
4
1
3 5
6