Tape drive, Removing and installing an internal tape drive, D and out of the chassis. see figure 3-22 – Dell PowerEdge 2970 User Manual
Page 87: Figure 3-22
Installing System Components
87
Figure 3-22.
Installing and Removing the Diskette Drive Into and From the Drive Carrier
Installing the Diskette Drive Into the Drive Carrier
1 Align the back of the diskette drive with the back of the carrier.
2 Add the shim to the drive.
3 Gently push the drive into the carrier until it pops in securely. See Figure 3-22.
Tape Drive
This section describes how to configure and install an internal SCSI or SATA tape drive.
NOTE:
Installing a SCSI tape drive requires an optional SCSI controller card.
Removing and Installing an Internal Tape Drive
NOTICE:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your Product Information
Guide
.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
1
diskette drive tray
2
shim
3
diskette drive
4
diskette drive release tabs (2)
4
1
3
2