Dell PowerEdge 2970 - Manual (Page 104)

104
Installing System Components
Removing the Center Riser Board
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Press the blue release tab in the center of the center riser to release the board from the system board
socket while easing both ends of the riser upward.
2 Lift the center riser board from the two guide pins on either end, and draw the riser away from the
system board.
Figure 3-31. Replacing the Center Riser Board
Installing the Center Riser Board
1 Fitting the two pin collars over the guide pins on the system board, gently lower the center riser board
until the board connector is firmly seated into the system board socket. See Figure 3-31.
1 pin collars (2) 2 release tab 3 center riser board
4 guide pins (2) 5 system board socket
4
3
2
5
1