Dell PowerEdge 2970 - Manual (Page 90)

90
Installing System Components
To remove the tape drive cable retention bracket, gently draw the blue release latch toward the center of
the system while sliding the cable retention bracket toward the front of the system and disengaging the
bracket from the chassis wall. See Figure 3-25.
To replace the bracket, align the bracket clips with their slots on the chassis wall, then slide the bracket
toward the back of the system until all the clips and the blue release latch are fully engaged.
Figure 3-25. Installing and Removing the Tape Drive Cable Retention Bracket
1 tape drive cable 2 SCSI controller card 3 release latch
4 bracket clips (6) 5 tape drive cable retention
bracket
2
1
3
4
5