Dell PowerEdge R200 - Manual (Page 27)

About Your System
27
SATA Port 0/1/2
hard disk not found
SATA Port 0/1/2 set as Auto,
no disk installed. Run the System Setup
program to correct the
settings. See "Using the
System Setup Program" on
page 35.
Sector not found
Seek error
Seek operation
failed
Faulty diskette or hard
drive. See "Troubleshooting a
USB Device" on page 102
or "Troubleshooting a Hard
Drive" on page 111 for the
appropriate drive installed
in your system.
Shutdown failure Shutdown test failure. Ensure that all memory
modules are properly
installed. See
"Troubleshooting System
Memory" on page 108. If
the problem persists, see
"Getting Help" on
page 127.
The amount of
system memory has
changed.
Faulty memory module.
Information only, if you
have changed the memory
configuration.
See "Troubleshooting
System Memory" on
page 108. If the problem
persists, see "Getting Help"
on page 127.
Faulty memory module. See "Troubleshooting
System Memory" on
page 108. If the problem
persists, see "Getting Help"
on page 127.
Time-of-day clock
stopped
Faulty battery; faulty
system board. See "Troubleshooting the
System Battery" on
page 106. If the problem
persists, see "Getting Help"
on page 127.
Table 1-4. System Messages (continued)
Message Causes Corrective Actions
book.book Page 27 Thursday, August 30, 2007 3:30 PM