Dell PowerEdge R200 - Manual (Page 34)

34
About Your System
Warning Messages
A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing
y (yes) or n (no).
NOTE:
Warning messages are generated by either the application or the operating
system. For more information, see the documentation that accompanied the
operating system or application.
Diagnostics Messages
When you run system diagnostics, an error message may result. Diagnostic
error messages are not covered in this section. Record the message on a copy
of the Diagnostics Checklist in "Getting Help" on page 127, and then follow
the instructions in that section for obtaining technical assistance.
Alert Messages
Systems management software generates alert messages for your system. Alert
messages include information, status, warning, and failure messages for drive,
temperature, fan, and power conditions. For more information, see the
systems management software documentation.
4-3-3 Faulty system board Faulty system board. See "Getting Help"
on page 127.
4-3-4 Time-of-day clock stopped See "Troubleshooting System Memory" on
page 108. If the problem persists, see
"Getting Help" on page 127.
4-4-1 Super I/O chip failure; faulty
system board Faulty system board. See "Getting Help"
on page 127.
4-4-4 Cache test failure; faulty
processor See "Troubleshooting the Microprocessor"
on page 114.
Table 1-6. System Beep Codes (continued)
Code Cause Corrective Action
book.book Page 34 Thursday, August 30, 2007 3:30 PM