Dell Dimension 4600 - Manual (Page 82)

82 A d d i n g Pa r t s
www
.dell.com | support.dell.com
3 Secure the card with the securing screw.
4 Replace the computer cover (see page 99).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
5 Connect your computer and devices to electrical outlets, and turn them on.
Adding or Replacing a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
CAUTION: To avoid damage to the drive, do not set it on a hard surface. Instead,
set the drive on a soft surface, such as a foam pad, that will sufficiently cushion
it.
1 Shut down the computer through the Start menu (see page 27).
2 Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer,
turn them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
3 Disconnect any telephone or telecommunication lines from the computer.
4 Disconnect your computer and all attached devices from their electrical outlets, and
then press the power button to ground the system board.
filler bracket
securing screw
J2936bk0.book Page 82 Tuesday, September 2, 2003 3:06 PM