Dell Dimension 4600 - Manual (Page 90)

90 A d d i n g Pa r t s
www
.dell.com | support.dell.com
18 Use the left and right arrows to change Diskette Drive A from Not Installed to
3.5 inch, 1.44MB.
19 Press <Enter>.
20 Highlight Integrated Devices (LegacySelect Options) and press <Enter>.
21 Make sure that the Diskette Interface entry is set to Auto. If necessary, use the left and
right arrows to set it to Auto.
22 Press <Enter>.
23 Press <Esc>.
24 Press <Enter> to save changes and exit.
The computer restarts.
See the documentation that came with the drive for instructions on installing any
software required for drive operation.
Adding a Second CD or DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
1 Shut down the computer through the Start menu (see page 27).
NOTE: Drives sold by Dell come with their own operating software and documentation. After
you install a drive, see the documentation that came with the drive for instructions on installing
and using the drive software.
2 Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer,
turn them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
3 Disconnect any telephone or telecommunication lines from the computer.
4 Disconnect your computer and all attached devices from their electrical outlets, and
then press the power button to ground the system board.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before opening the cover.
5 Remove the computer cover (see page 74).
J2936bk0.book Page 90 Tuesday, September 2, 2003 3:06 PM