Dell Alienware 17 R2 (Early 2015) - Manual (Page 104)

Replacing the display bezel
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in Before working inside your computer .
After working inside your computer, follow the instructions
in After working inside your computer . For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
NOTE: This chapter is applicable only if you have purchased a laptop with
non-touchscreen display.
1 Adhere the logo board on the display bezel.
2 Connect the logo-board cable to the logo board and adhere the adhesive
tape.
3 Slide the display-board cables to their respective connectors on the logo
board and press down the latches to secure the cables.
4 Turn the display bezel over.
5 Align the display bezel with the display back-cover and gently snap the
display bezel into place.
Post-requisites
1 Replace the display assembly .
2 Follow the procedure from step 5 to step 11 in “Replacing the palm rest ”.
3 Replace the wireless card .
4 Replace the base panel .
104