Dell PowerEdge 800 - Manual (Page 15)

12. Reinstall the drive cage and secure it with the four Phillips screws. See Figure 7 -6 in "Installing Drives."
13. Reconnect the SCSI or SATA interface cable(s) to the system board or optional hard-drive controller card.
Ensure that you reattach the interface cables in their original locations.
14. Reconnect the power cables to the hard drives in the drive cage, or to the optional SCSI backplane.
15. Replace the cooling shroud. See " Installing the Cooling Shroud " in "Installing System Options."
16. Connect the two power cables to connectors PWR_CONN and 12V on the system board.
17. Carefully check for any remaining cables or components that are not installed or are improperly seated in their connectors on the system board.
18. Close the system. See " Replacing the Cover " in "Troubleshooting Your System."
19. Lift the system upright.
20. Reinstall the bezel. See " Installing the Bezel " in "Troubleshooting Your System."
21. Reconnect the cables to the I/O connectors on the system back panel.
22. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Back to Contents Page