Dell PowerEdge 800 - Manual (Page 36)

2. Ensure that no tools or loose parts are left inside the system.
3. Fit the cover on the side of the system, and slide the cover backward.
4. Tighten the cover thumbscrew to secure the cover.
Installing the Bezel
To install the bezel, align the hooks at the bottom of the bezel, swing the top of the bezel toward the system, and press the bezel onto the system until it
snaps into place. Using the system key, lock the bezel.
Inside the System
In Figure 5 -3 , the bezel and system cover are removed to provide an interior view of the system.
Figure 5-3. Inside the System
The system board holds the system's control circuitry and other electronic components. The processor and memory are installed directly on the system board.
The system can accommodate up to five expansion cards.
The system supports up to four SCSI or SATA hard drives. The peripheral bays support an optional diskette drive and optical drive.
Troubleshooting a Wet System
Problem
l Liquid spilled on the system.
l Excessive humidity.
Action
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See " Opening the System ."
3. Remove all expansion cards installed in the system. See " Removing an Expansion Card " in "Installing System Components."
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.