Dell Broadcom NetXtreme Family of Adapters - Manual (Page 133)

Broadcom Teaming Services: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/teamsvcs.htm[9/5/2014 3:45:08 PM]
19 Error
This driver does not
support this device.
Upgrade to the latest
driver.
The driver does not recognize
the installed adapter.
Upgrade to a driver version that supports
this adapter.
20 Error
Driver initialization
failed.
Unspecified failure during
driver initialization.
Reinstall the driver, update to a newer
driver, run Broadcom Advanced Control
Suite diagnostics, or replace the adapter.
21 Informational
Network controller
configured for 10Gb
full-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
22 Error
Network controller
failed initialization
because it cannot
allocate system
memory.
Insufficient system memory
prevented the initialization of
the driver.
Increase system memory.
23 Error
Network controller
failed to exchange the
interface with the bus
driver.
The driver and the bus driver
are not compatible.
Update to the latest driver set, ensuring the
major and minor versions for both NDIS and
the bus driver are the same.
Intermediate Driver (Virtual Adapter/Team)
The intermediate driver is identified by source BLFM, regardless of the base driver revision. Table 9 lists the event log
messages supported by the intermediate driver, explains the cause for the message, and provides the recommended action.
Table 9: Intermediate Driver Event Log Messages
System
Event
Message
Number
Severity Message Cause Corrective Action
1 Informational
Event logging enabled for
Broadcom Advanced
Server Program driver.
– No action is required.
2 Error
Unable to register with
NDIS.
The driver cannot register
with the NDIS interface.
Unload other NDIS drivers.
3 Error
Unable to instantiate the
management interface.
The driver cannot create a
device instance.
Reboot the operating system.
4 Error
Unable to create symbolic
link for the management
interface.
Another driver has created a
conflicting device name.
Unload the conflicting device driver that
uses the name Blf.
5 Informational
Broadcom Advanced
Server Program Driver has
started.
The driver has started. No action is required.
6 Informational
Broadcom Advanced
Server Program Driver has
stopped.
The driver has stopped. No action is required.
7 Error
Could not allocate memory
for internal data
structures.
The driver cannot allocate
memory from the operating
system.
Close running applications to free
memory.
8 Warning Could not bind to adapter.
The driver could not open
one of the team physical
adapters.
Unload and reload the physical adapter
driver, install an updated physical
adapter driver, or replace the physical
adapter.
9 Informational Successfully bind to
adapter.
The driver successfully
opened the physical adapter. No action is required.
10 Warning
Network adapter is
disconnected.
The physical adapter is not
connected to the network (it
has not established link).
Check that the network cable is
connected, verify that the network cable
is the right type, and verify that the link
partner (switch or hub) is working
correctly.