Dell Broadcom NetXtreme Family of Adapters - Manual (Page 134)

Broadcom Teaming Services: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/teamsvcs.htm[9/5/2014 3:45:08 PM]
11 Informational Network adapter is
connected.
The physical adapter is
connected to the network (it
has established link).
No action is required.
12 Error
Broadcom Advanced
Program Features Driver is
not designed to run on this
version of Operating
System.
The driver does not support
the operating system on
which it is installed.
Consult the driver release notes and
install the driver on a supported
operating system or update the driver.
13 Informational
Hot-standby adapter is
selected as the primary
adapter for a team without
a load balancing adapter.
A standby adapter has been
activated.
Replace the failed physical adapter.
14 Informational Network adapter does not
support Advanced Failover.
The physical adapter does
not support the Broadcom
NIC Extension (NICE).
Replace the adapter with one that does
support NICE.
15 Informational
Network adapter is
enabled via management
interface.
The driver has successfully
enabled a physical adapter
through the management
interface.
No action is required.
16 Warning
Network adapter is
disabled via management
interface.
The driver has successfully
disabled a physical adapter
through the management
interface.
No action is required.
17 Informational
Network adapter is
activated and is
participating in network
traffic.
A physical adapter has been
added to or activated in a
team.
No action is required.
18 Informational
Network adapter is de-
activated and is no longer
participating in network
traffic.
The driver does not
recognize the installed
adapter.
No action is required.
19 Informational
The LiveLink feature in
BASP connected the link
for the network adapter.
The connection with the
remote target(s) for the
LiveLink-enabled team
member has been
established or restored
No action is required.
20 Informational
The LiveLink feature in
BASP disconnected the link
for the network adapter.
The LiveLink-enabled team
member is unable to connect
with the remote target(s).
No action is required.
Virtual Bus Driver (VBD)
Table 10: Virtual Bus Driver (VBD) Event Log Messages
Message
Number Severity
Message Cause Corrective Action
1 Error
Failed to allocate
memory for the device
block. Check system
memory resource
usage.
The driver cannot
allocate memory from
the operating system.
Close running applications to free memory.
2 Informational
The network link is
down. Check to make
sure the network cable
is properly connected.
The adapter has lost its
connection with its link
partner.
Check that the network cable is connected,
verify that the network cable is the right type,
and verify that the link partner (for example,
switch or hub) is working correctly.
3 Informational The network link is up.
The adapter has
established a link.
No action is required.
4 Informational
Network controller
configured for 10Mb
half-duplex link.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
No action is required.
Network controller
The adapter has been