Dell Broadcom NetXtreme Family of Adapters - Manual (Page 224)

User Diagnostics in DOS: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/userdiag.htm[9/5/2014 3:45:19 PM]
uxdiag -fnvm
<raw_image>
Programs the raw image into NVM.
uxdiag -fump
<ump_image>
Specifies the bin file to update UMP firmware.
uxdiag -help Displays the Broadcom NetXtreme II User Diagnostics (uxdiag) command options.
uxdiag -I <iteration
num>
Specifies the number of iterations to run on the selected tests.
uxdiag -idmatch
Enables matching of VID, DID, SVID, and SSID from the image file with device IDs. Used only with
-fnvm <raw_image>.
uxdiag -log <file> Logs the test results to a specified log file.
uxdiag -mba <1/0>
Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
uxdiag -mbap <n>
Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot
uxdiag -mbas <n>
Sets the MBA/PXE speed.
0 = Auto
1 = 10H
2 = 10F
3 = 100H
4 = 100F
6 = 1000F
uxdiag -mbav <1|0>
Enables/disables MBA VLAN.
1 = Enable
0 = Disable
uxdiag -mbavval <n> Sets MBA VLAN (<65536).
uxdiag -mfw <1/0>
Enables/disables management firmware.
1 = Enable
0 = Disable
uxdiag -t
<groups/tests>
Disables certain groups/tests.
uxdiag -T
<groups/tests>
Enables certain groups/tests.
uxdiag -ver Displays the version of Broadcom NetXtreme II User Diagnostics (uxdiag) and all installed adapters.
uxdiag -wol <1/0>
Enables/disables Magic Packet WOL.
1 = Enable
0 = Disable
Table 2: uediag Command Options
Command Options Description
uediag Performs all tests on all Broadcom NetXtreme II adapters in your system.
uediag -c <device#> Specifies the adapter (device#) to test. Similar to -dev (for backward compatibility).
uediag -cof Allows tests to continue after detecting a failure.
uediag -dev <device#> Specifies the adapter (device#) to test.
uediag -F
Forces an upgrade of the image without checking the version.
uediag -fbc
<bc_image>
Specifies the bin file to update the bootcode.
uediag -fbc1
<bc1_image>
Specifies the bin file to update bootcode 1.
uediag -fbc2
<bc2_image>
Specifies the bin file to update bootcode 2.
uediag -fl2b
<l2b_image>
Specifies the bin file for L2B firmware.
uediag -fib <ib_image> Specifies the bin file for iSCSI boot.