Dell Vostro V130 (Late 2010) - Manual (Page 22)

18. Pull the cables out from the openings in the palmrest assembly to release the display assembly from the palmrest
assembly.
NOTE: To install the palmrest and display assembly, see Installing The Palmrest and Display Assembly
Installing The Palmrest and Display Assembly
NOTE: To remove or locate the system board, see Removing The Palmrest and Display Assembly .
1. Route all the cables from the display assembly into the openings in the palmrest assembly.
2. Align the palmrest and display assembly with the base of the computer.
3. Tighten the screws to secure the palmrest and display assembly to the base of the computer.
4. Route the antenna cables to their original position and use the cloth tape to secure them to the computer.
5. Install the system board .
6. Install the thermal fan .
7. Install the coin-cell battery .
8. Install the card reader .
9. Install the keyboard .
10. Install the memory .
11. Install the LED cover .
12. Install the wireless wide area network (WWAN) card .
13. Install the wireless local area network (WLAN) card .
14. Install the audio board and hard drive .
15. Install the battery .
16. Install the base cover .
17. Install the Secure Digital (SD) card .
18. Follow the procedures in After Working Inside Your Computer .
22