Dell Vostro V130 (Late 2010) - Manual (Page 37)

Installing The System Board
NOTE: To remove or locate the system board, see Removing The System Board .
1. Place the system board in its location on the base of the computer.
2. Tighten the screws that secures the system board to the computer.
3. Connect the camera cable , thermal fan cable, coin-cell battery cable, hard disk cable, SD card reader cable, SIM
card reader cable, touch pad flex cable, and LED board cable to the system board.
4. Replace and guide the antenna cables back through the cloth tapes to its original positions.
5. Turn the computer over and connect the display cable to the computer.
6. Install the keyboard .
7. Install the memory .
8. Install the LED cover .
9. Install the wireless wide area network (WWAN) card .
10. Install the wireless local area network (WLAN) card .
11. Install the battery .
12. Install the base cover .
13. Install the Secure Digital (SD) card .
14. Follow the procedures in After Working Inside Your Computer .
37