Base cover, Removing the base cover, Replacing the base cover – Dell Studio 1749 (Early 2010) User Manual
Page 3
Back to Contents Page
Base Cover
Dell Studio™ 1745/1747 Service Manual
Removing the Base Cover
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the six screws that secure the base cover to the computer base.
4.
Lift the base cover off the computer at an angle as shown in the following illustration.
Replacing the Base Cover
1.
Follow the procedures in
Before You Begin
.
2.
Align the four tabs on the base cover with the slots on the computer base and gently snap it into place.
3.
Replace the six screws that secure the base cover to the computer base.
4.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
screws (6)
2
base cover
3
tabs (4)