Palm rest, Removing the palm rest – Dell Studio 1749 (Early 2010) User Manual
Page 44
Back to Contents Page
Palm Rest
Dell Studio™ 1745/1747 Service Manual
Removing the Palm Rest
1.
Follow the procedures in
Before You Begin
.
2.
Press and eject any installed cards from the ExpressCard slot or the 8-in-1 media card reader.
3.
Remove the battery (see
Removing the Battery
).
4.
Remove the base cover (see
Removing the Base Cover
).
5.
Disconnect the antenna cables from the Mini-Card(s) (see
Removing the Mini-Card
).
6.
Disconnect the subwoofer assembly cable from the subwoofer assembly cable connector on the system board.
7.
Remove the twelve screws from the computer base.
8.
Remove the center control cover (see
Removing the Center Control Cover
).
9.
Remove the keyboard (see
Removing the Keyboard
).
10.
Remove the media controls board (see
Removing the Media Controls Board
).
11.
Remove the six screws on the palm rest.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.