Entering the service tag in the bios – Dell Studio 1749 (Early 2010) User Manual
Page 56
9.
Replace the optical drive (see
Replacing the Optical Drive
).
10.
Replace the media card reader board (see
Replacing the Media Card Reader Board
).
11.
Replace the thermal fan (see
Replacing the Thermal Fan
).
12.
Replace the Bluetooth card (see
Replacing the Bluetooth Card
).
13.
Replace the palm rest (see
Replacing the Palm Rest
).
14.
Replace the media controls board (see
Replacing the Media Controls Board
).
15.
Replace the keyboard (see
Replacing the Keyboard
).
16.
Replace the center control cover (see
Replacing the Center Control Cover
).
17.
Replace the coin-cell battery (see
Replacing the Coin-Cell Battery
).
18.
Replace the hard drive(s) (see
Replacing the Hard Drive(s)
).
19.
Replace the Mini-Card(s) (see
Replacing the Mini-Card
).
20.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
21.
Replace the base cover (see
Replacing the Base Cover
).
22.
Replace the battery (see
Replacing the Battery
).
23.
Reinstall any removed cards in the ExpressCard slot or the 8-in-1 media card reader.
24.
Turn on the computer.
25.
Enter the service tag (see
Entering the Service Tag in the BIOS
Entering the Service Tag in the BIOS
1.
Ensure that the AC adapter is plugged in and that the main battery is installed properly.
2.
Turn on the computer.
3.
Press <F2> during POST to enter the system setup program.
4.
Navigate to the security tab and enter the service tag in the Set Service Tag field.
Back to Contents Page
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
NOTE:
After you have replaced the system board, enter the computer Service Tag in the BIOS of the replacement system board.