Removing a redundant power supply – Dell Powervault NX400 User Manual
Page 67
output voltage of the active power supply. If the output voltage of the active power supply drops, the redundant power
supply in the sleep state returns to an active output state.
The active power supply can also activate a sleeping power supply if having both power supplies active is more efficient
than having the redundant power supply in a sleep state. The power supply defaults are to wake both power supplies if
the load on the active power supply is greater than 50% and to sleep the redundant power supply if the load falls below
20%.
You can configure the Hot Spare feature using the iDRAC settings. For more information on iDRAC settings, see the
iDRAC7 User's Guide
under Software → Systems Management → Dell Remote Access Controllers , at support.dell.com/
manuals.
Removing A Redundant Power Supply
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
CAUTION: The system requires one power supply for normal operation. On power-redundant systems, remove and
replace only one power supply at a time in a system that is powered on.
1.
Disconnect the power cable from the power source.
2.
Disconnect the power cable from the power supply and remove the straps that bundle and secure the system
cables.
NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with power-supply
removal. For information about the cable management arm, see the system’s rack documentation.
3.
Press the release latch and pull the power supply straight out to release it from the power distribution board and
clear the chassis.
Figure 30. Removing and Installing a Redundant Power Supply
1. redundant power supply unit
2. release latch
3. power supply handle
67