Dell M5200 Medium Workgroup Mono Laser Printer User Manual
Page 135
Printing Font List
The printer is processing or printing
a list of all available fonts for the
specified printer language.
Wait for the message to clear.
See also:
Print Fonts
Printing Menu
Settings
The printer is processing or printing
the menu settings page.
Wait for the message to clear.
See also:
Print Menus
;
Printing a menu
settings page
Prog System Code
DO NOT POWER
OFF
The printer is programming new
system code.
Wait for the message to clear and the printer
to reset.
Do not turn the printer off while this message
is displayed.
Queuing and
Deleting Jobs
The printer is deleting one or more
held jobs and sending one or more
jobs to print.
Wait for the message to clear.
See also:
Using the Print and Hold function
Queuing Jobs
The printer is sending one or more
held jobs to print.
Wait for the message to clear.
See also:
Using the Print and Hold function
Ready
The printer is ready to receive and
process print jobs.
Send a job to print.
Ready Hex
The printer is in Hex Trace mode
and is ready to receive and process
print jobs.
Send a job to print. All data sent to the
printer is printed in hexadecimal and
character representation. Control
strings are printed, not executed.
Turn the printer off and then on to exit
Hex Trace mode and return to Ready
status.
Reattach
<device>
The envelope feeder is either not
fully connected to the printer or is
experiencing a hardware failure.
Reestablish communication by removing
the envelope feeder and reattaching it
to the printer.
Press Go to clear the message and
continue printing without using the
envelope feeder.
In the case of a hardware failure, turn
the printer off and back on. If the error
recurs, turn the printer off, remove the
envelope feeder, and call Dell at
support.dell.com.
See also:
Contacting service
Remove Paper
<standard bin>
The output bin is full.
Remove the stack of paper from the standard
bin to clear the message.
Res Reduced
The printer is reducing the
resolution of a page in the current
job from 600 dots per inch (dpi) to
300 dpi to prevent a 38 Memory
Full
error. Res Reduced remains
on the display while the job prints.
Press Menu to open the Job Menu and cancel
the current job.