Dell M5200 Medium Workgroup Mono Laser Printer - Manual (Page 137)

Waiting The printer has received a page of
data to print but is waiting for an
End of Job command, a Form Feed
command, or additional data. Press Go to print the contents of the
buffer.
Press Menu to open the Job Menu and
cancel the current job.
See also: Canceling a print job
1565 Emul Error
Load Emul Option The download emulator version on
the firmware card does not match
the printer code version.
This error can occur if you update
printer firmware or move a
firmware card from one printer to
another.
The printer automatically clears the message
in 30 seconds, and then disables the
download emulator on the firmware card.
2<xx> Paper Jam The printer detects a jam. Clear the paper path.
See also: Clearing jams
23x Duplex Jam The printer detects a jam in the
optional duplex unit. Clear the paper path.
See also: Clearing jams
32 Unsupported
print cartridge An unsupported toner cartridge is
installed. Remove the toner cartridge and install a new
one.
See also: Replacing the toner cartridge
34 Short Paper The printer has determined that the
length of the paper in the source
specified on the second line of the
display is too short to print the
formatted data. For auto-size
sensing trays, this error occurs if
the guides are not in the correct
position. Press Go to clear the message and
continue printing. The printer does not
automatically reprint the page that
prompted the message.
Make sure the Paper Size setting in the
Paper Menu is correct for the size paper
you are using. If MP Feeder Size is set
to Universal, make sure your paper is
large enough for the formatted data.
Press Menu to open the Job Menu and
cancel the current job.
See also: Print media guidelines
35 Res Save Off
Deficient Memory The printer lacks the memory
needed to enable Resource Save.
This message usually indicates too
much memory is allocated for one
or more of the printer link buffers. Press Go to disable Resource Save and
continue printing.
To enable Resource Save after you get
this message:
Make sure the link buffers are set
to Auto, and exit the menus to
activate the link buffer changes.
When Ready is displayed, enable
Resource Save from the Setup
Menu.
Install additional memory.
37 Insufficient
Collation Area The printer memory does not have
the free space necessary to collate
the print job. Press Go to print the portion of the job
already stored and begin collating the
rest of the job.
Press Menu to open the Job Menu and
cancel the current job.