Dell OptiPlex GX60 User Manual
Page 158
5.
Attach the serial adapter cable to the serial port connector on the system board (labeled SER2).
6.
Close the computer cover, reconnect the computer and devices to their electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
7.
Reset the chassis intrusion detector
by changing Chassis Intrusion to Enabled or Enabled-Silent.
Back to Contents Page
1 SER2 system board connector
2 card bracket
3 serial card cable
4 card slot opening
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.