Dell OptiPlex GX60 User Manual
Page 25
6.
Close the computer cover, and plug your computer and devices into electrical outlets.
7.
Attach the computer stand, if it is used.
8.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
9.
Reset the chassis intrusion detector
by changing Chassis Intrusion to Enabled or Enabled-Silent.
10.
Enter system setup
and restore the settings you recorded in step 1.
11.
Properly dispose of the old battery.
Back to Contents Page
NOTICE:
To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.