Dell OptiPlex GX60 - Manual (Page 162)

2. Align pin 1 (the imprinted corner) of the processor and pin 1 of the socket.
3. Carefully set the processor in the socket and press it down lightly to seat it.
4. Rotate the release lever back toward the system board until it snaps into place, securing the processor.
5. Install the heat sink:
a. Insert the notched end of the heat sink onto the end of the retention base that is opposite the hinge.
b. Lower the heat sink until it fits securely in the base.
6. Raise the retention lever and press until the heat sink is secured. You will feel the lever pause once it is at a 90-degree angle. Keep pressing the lever
another 30 degrees, ensuring that it is in the locked position.
7. Lower the airflow shroud over the heat sink.
If you installed a processor replacement kit from Dell, return the original heat-sink assembly and processor to Dell in the same package in which your
1 pin-1 corners of processor and socket aligned
NOTICE: Processor pins are delicate. To avoid damage, ensure that the processor aligns properly with the socket, and do not use excessive force when
you install the processor.
1 heat sink
2 lever
3 hinge
4 retention base
5 notch