Small mini-tower computer – Dell OptiPlex GX60 User Manual
Page 68
1.
Follow the procedures in "
Before You Begin
."
2.
Disconnect the DC power cables from the system board and the drives.
Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them from the system board and drives. You must
route these cables properly when you replace them to prevent their being pinched or crimped.
3.
Remove the expansion-card cage and remove the power cables from the side of the hard drive. To remove the power cables, use the cables as
leverage and pull away from the clips while you pull on the metal clips with your fingers.
4.
Press down on the handle, which in turn presses the release button.
5.
Slide the power supply toward the front of the computer approximately 1 inch.
6.
Lift the power supply up and out of the computer.
Small Mini-Tower Computer
1.
Follow the procedures in "
Before You Begin
."
2.
Disconnect the DC power cables from the system board and the drives.
Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them from the system board and drives. You must
route these cables properly when you replace them to prevent their being pinched or crimped.
3.
Remove the two screws that attach the power supply to the back of the computer frame.
4.
Press the release button located on the floor of the computer frame.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions
.
1
release button
2
handle
3
AC power connector
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions
.