Dell PowerVault MD1120 User Manual
Page 33
Advertising
Installing Enclosure Components
33
Removing an EMM
NOTICE:
If you remove an EMM from an enclosure operating in split mode while
connected to a host server, you will lose connection to the physical disks attached
to the removed EMM.
1 Push up on the release tab on the left side of the module (see Figure 3-4).
2 At the same time, pull out on the release lever. When the lever is pulled
out, the EMM partially ejects from the enclosure.
3 Remove the module from the enclosure and place it on a flat, secure
surface.
NOTE:
To avoid damage to the sensitive EMI contacts on the bottom of the
EMM, do not stack EMMs or place them on a hard surface.
Figure 3-4.
Removing and Installing an EMM
1
release tab
2
release lever
2
1
Advertising