Dell PowerVault MD1120 - Manual (Page 39)

Installing Enclosure Components
39
Installing the Control Panel
1 Align the top and bottom channels on the control panel with the insert
slots on the edge of the chassis (see Figure 3-7).
2 Slide the control panel into the slot, pulling the release plunger toward the
inside of the enclosure. Once the control panel is halfway into the slot,
release the release plunger and push the panel fully into the enclosure. The
release plunger will snap into place when it seats securely into the
backplane connector.
3 Re-install any physical disks you removed (see "Removing and Installing
Physical Disks" on page 28).
4 Reconnect power cables to the enclosure and power it back on.
5 Power on the host server.
Removing and Installing the Midplane
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
The enclosure midplane contains the connectors for the physical disks,
EMMs, control panel, and power supply/cooling modules.
1 Complete the "Removing the Control Panel" on page 37 steps as shown in
"Removing and Installing the Control Panel" on page 37.
2 Remove the EMMs from the enclosure. (See "Removing and Installing an
EMM" on page 33).
3 Remove both power supply/cooling modules from the enclosure. (See
"Removing and Installing the Power Supply/Cooling Fan Module" on
page 35.)
4 Remove the seven Phillips screws holding the EMM/power supply cage in
the enclosure (see Figure 3-8).