Dell PowerVault MD1120 User Manual
Page 40
Advertising
40
Installing Enclosure Components
Figure 3-8.
Removing and Replacing the EMM/Power Supply Cage
5 Grasp the cage removal ring in the bottom center of the rear enclosure.
Pull out and lift up and over the alignment pins to remove the cage from
the enclosure.
6 Remove the six Phillips screws holding the midplane in place and pull it
out of the enclosure. (See Figure 3-9.)
7 To re-install the midplane, reverse the previous steps.
1
screws (7)
3
alignment pin (6)
2
removal ring
4
EMM/power supply cage
4
3
2
1
Advertising