Dell Dimension 9200c - Manual (Page 58)

Removing and Installing Parts: Dell Dimension 9200C Service Manual
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
Modem
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: Before you remove or install the modem, make sure to disconnect all telephone and network cables from
your computer.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
Replacing the Modem
1. Follow the procedures in Before You Begin .
2. Remove the hard drive (see Removing a Hard Drive ).
NOTE: For easier access to the modem, it may be necessary to remove the power cable from the power connector
(POWER) on the system board (see System Board Components ).
3. Remove the existing modem:
a. Remove the modem cable from the RJ11 internal connector.
b. Use a small Phillips screwdriver to remove the two screws securing the modem to the system board, and then
set the screws aside.
c. Pull straight up on the attached pull-tab to lift the modem out of its connector on the system board.
d. Remove the modem cable from the modem.
1 pull tab 2 modem
cable
3 screws (2)
4 RJ11 internal connector 5 modem 6 T-shaped connector attached to the