Dell Dimension 9200c - Manual (Page 60)

Removing and Installing Parts: Dell Dimension 9200C Service Manual
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
1 power supply screws (3)
5. Slide the power supply approximately 1 inch toward the front of the computer.
6. Carefully lift the power supply out of the computer.
Replacing the Power Supply
1. Lower the power supply into the computer and slide the power supply toward the back of the computer.
2. Replace the three power supply screws.
3. Reconnect all DC power cables.
4. Replace the computer cover (see Replacing the Computer Cover ).
5. Connect the AC power cable to the power supply connector.
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the
computer.
6. Connect your computer and devices to electrical outlets, and then turn them on.
System Board
Removing the System Board