Dell Dimension 9200c - Manual (Page 62)

Removing and Installing Parts: Dell Dimension 9200C Service Manual
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
NOTE: Some components and connectors on the replacement system board may be in different locations from
corresponding connectors on the existing system board.
3. Transfer components from the existing system board to the replacement system board:
a. Remove the memory modules and install them on the replacement system board (see Memory ).
CAUTION: The heat sink assembly and processor package can get hot. To avoid burns, ensure that the
assembly and package have had sufficient time to cool before you touch them.
b. Remove the heat sink assembly (see Removing the Heat Sink Assembly ) and processor package (see Removing
the Processor ) from the existing system board and transfer them to the replacement system board.
c. Remove the modem from the existing system board and transfer it to the replacement system board (see
Modem ).
4. Replace any components and cables that you removed from the original system board.
5. Reconnect all cables to their connectors at the back of the computer.
6. Replace the computer cover (see Replacing the Computer Cover ).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
7. Connect your computer and devices to electrical outlets, and then turn them on.
NOTE: If the new system board requires the BIOS to be updated, refer to Flashing the BIOS .
8. Set the jumpers on the replacement system board so that they are identical to the ones on the existing system board
(see Jumper Settings ).
Front I/O Panel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
Removing the Front I/O Panel
1. Follow the procedures in Before You Begin .
2. Remove the heat sink (see Removing the Heat Sink Assembly ).
3. Remove the fan assembly (see Removing the Fan Assembly ).
4. Remove any additional components that restrict access to the I/O panel.
5. Remove the screw that secures the front I/O panel to the computer.
6. Pivot the I/O panel toward the back of the computer, and then carefully lift it up and out of the computer.
7. Disconnect any cables that are attached to the front I/O panel.