Dell PowerVault NX300 - Manual (Page 130)

130
Installing System Components
3 Remove the system board shroud. See "Removing the System Board
Shroud" on page 101.
Figure 3-25. Replacing the System Battery
4 Locate the battery socket. See "Jumpers and Connectors" on page 171.
CAUTION:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 Remove the system battery.
a Support the battery connector by firmly holding the positive side of
the connector.
b Press the battery toward the negative side of the connector and lift it
up out of the securing tab at the negative side of the connector.
6 Install the new system battery.
a Support the battery connector by pressing down firmly on the positive
side of the connector.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
2
3
1
book.book Page 130 Thursday, August 13, 2009 7:27 AM