Dell PowerVault NX300 - Manual (Page 54)

54
About Your System
Warning Messages
A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
Warning!
Unsupported
memory
configuration
detected. The
memory
configuration is
not optimal. The
recommended
memory
configuration
is: <message>
Invalid memory
configuration. The system
will run but with reduced
functionality. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 115.
If the problem persists,
see "Troubleshooting System
Memory" on page 154.
Write fault
Write fault on
selected drive
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard
drive subsystem. Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected.
See "Troubleshooting a USB
Device" on page 148,
"Troubleshooting an Internal
USB Key" on page 156,
"Troubleshooting an Optical
Drive" on page 157, and
"Troubleshooting a Hard
Drive" on page 158.
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
"Glossary" on page 179.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 54 Thursday, August 13, 2009 7:27 AM