Dell PowerVault NX300 - Manual (Page 89)

Installing System Components
89
Figure 3-7. Removing and Replacing a Redundant Power Supply
Installing a Redundant Power Supply
1 Verify that both power supplies are the same type and have the same
maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the power supply
label.
2 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-7.
NOTE:
If you unlatched the cable management arm in step 2 of the previous
procedure, relatch it. For information about the cable management arm, see the
system’s rack documentation.
CAUTION:
When connecting the power cable, secure the cable with the
Velcro strap.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
1 power supply 2 locking tab
3 cable retention bracket
1
2
3
book.book Page 89 Thursday, August 13, 2009 7:27 AM