Dell POWEREDGE M1000E - Manual (Page 265)

Fabric OS Administrator’s Guide 225
53-1001763-02
Configuring logical switches to use basic configuration values
10
Example
The following example checks whether VF mode is enabled or disabled and then disables it.
switchA:FID128:admin> fosconfig --show
FC Routing service:
disabled
iSCSI service: Service not supported on this Platform
iSNS client service: Service not supported on this Platform
Virtual Fabric: enabled
switch:admin> fosconfig --disable vf
WARNING:
This is a disruptive operation that requires a reboot to take
effect.
Would you like to continue [Y/N] y
Configuring logical switches to use basic configuration values
All switches in the fabric are configured to use the same basic configuration values. When you
create logical switches, the logical switches might have different configuration values than the
default logical switch. Use the following procedure to ensure that newly created logical switches
have the same basic configuration values as the default logical switch.
NOTE
For most users, you do not need to run this procedure. Contact your switch service provider to
determine if you need to use this procedure.
You need to run this procedure only once on each chassis, after you enable Virtual Fabrics but
before you create logical switches. The configuration settings are then preserved across reboots
and firmware upgrades and downgrades.
1. Connect to the physical chassis and log in using an account assigned to the admin role with
the chassis-role permission.
2. Enter the following command to ensure that newly created logical switches have the same
basic configuration values as the default logical switch.
configurechassis
3. Enter n at the prompts to configure system and cfgload attributes. Enter y at the prompt to
configure custom attributes.
System (yes, y, no, n): [no] n
cfgload attributes (yes, y, no, n): [no] n
Custom attributes (yes, y, no, n): [no] y
4. Enter the appropriate value at the Config Index prompt. Contact your switch service provider to
determine the appropriate value.
Config Index (0 to ignore): (0..1000) [3]:
Creating a logical switch or base switch
When the logical switch is created, it is automatically enabled and is empty—that is, it does not
have any ports. After creating the logical switch, you must disable the switch to configure it and set
the domain ID. Then you assign ports to the logical switch.