Admin domain features, Requirements for admin domains – Dell POWEREDGE M1000E User Manual
Page 377
Fabric OS Administrator’s Guide
337
53-1001763-02
Administrative Domains overview
15
Admin Domain features
Admin Domains allow you to:
•
Define the scope of an Admin Domain to encompass ports and devices within a switch or a
fabric.
•
Share resources across multiple Admin Domains. For example, you can share array ports and
tape drives between multiple departments. In
on page 336, one of the storage
devices is shared between AD1 and AD2.
•
Have a separate zone database for each Admin Domain. See
on page 360 for more information.
•
Move devices from one Admin Domain to another without traffic disruption, cable reconnects,
or discontinuity in zone enforcement.
•
Provide strong fault and event isolation between Admin Domains.
•
Have visibility of all physical fabric resources. All switches, E_Ports, and FRUs (including blade
information) are visible.
•
Continue to run existing third-party management applications. Prior and existing versions of
third party management applications continue to work with admin and user IDs.
ATTENTION
The Admin Domain administrator can define up to 254 ADs (AD1 – AD254) in the AD database;
however, it is recommended that no more than 16 active Admin Domains run concurrently. More
than 16 active Admin Domains might cause performance degradation and unpredictable system
behavior.
Requirements for Admin Domains
Implementing Admin Domains in a fabric has the following requirements:
•
Admin Domains are not supported on the Brocade 8000. The Brocade 8000 can be in AD0
only.
•
The default zone mode setting must be set to No Access before you create Admin Domains
(see
“Setting the default zoning mode for Admin Domains”
on page 344 for instructions).
•
Virtual Fabrics must be disabled before you create Admin Domains (see
on page 224 for instructions).
•
The fabric must be in the native operating mode. Admin Domains are not supported in
interoperability mode.
•
Gigabit Ethernet (GbE) ports cannot be members of an Admin Domain.
•
Traffic Isolation is supported within Admin Domains, with some restrictions, as described in
“Admin Domain considerations for Traffic Isolation Zoning”
•
If the fabric includes LSAN zones:
-
The LSAN zone names must not end with “_ADn”.
-
The LSAN zone names must not be longer than 57 characters.
See
Chapter 21, “Using the FC-FC Routing Service,”
for information about the FC-FC Routing
Service and LSAN zones.