Dell PowerEdge R210 II - Manual (Page 55)

Installing System Components 55
Removing a Filler Panel
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 50.
3 If installed, remove the front bezel. See "Removing the Front Bezel" on
page 49.
4 Pull the filler panel away from the chassis.
Figure 5-5. Removing and Installing a Filler Panel
Installing a Filler Panel
1 Slide the filler panel into the bay until it clicks into place. See Figure 5-5.
2 Replace the front bezel. See "Installing the Front Bezel" on page 49.
3 Close the system. See "Closing the System" on page 51.
1 filler panel
1
book.book Page 55 Friday, March 7, 2014 1:35 PM