Dell POWEREDGE 840 - Manual (Page 51)

Installing System Components
51
Figure 3-6. Installing or Removing an Optical or Tape Drive
7 If a controller card was supplied with the drive, install the controller card in expansion slot 3, 4, or 5.
See "Installing an Expansion Card" on page 72.
8 Connect a power cable to the drive. See Figure 3-6.
9 Connect the interface cable to the drive and to the appropriate connector on the system board or
controller card (if applicable).
NOTE:
See the documentation that is included with the controller card for more information.
If you are installing an IDE device (such as an optical drive), connect the interface cable to the IDE
device and the IDE connector on the system board. See Figure 3-7.
1 5.25-inch drive 2 drive bay 3 screws (2)
4 power cable 5 interface cable
1
2
4
5
3