Dell Compellent Series 30 - Manual (Page 20)

14 Storage Center System Setup Guide
Setting Up the Storage Center
Controller Information
To add a controller to the Storage Center, complete the information in the Add Controller
dialog.
Figure 8. Controller IP Information
1 Enter the following:
• Controller ID: If the peer controller’s Hardware Serial Number (HSN) is included in
the license file, the Add Controller process uses that value as the Controller ID and
users cannot enter a different value. If the HSN is not in the license file, users are
allowed to enter a HSN value. The grayed-out field in the figure above indicates the
HSN was in the license file making the Controller ID field un-editable by users.
• Ether 0 Interface: Enter the IP Address, Netmask, and Gateway for the Ether 0
interface for the current controller.
• Ether 1 Interface: (Used for communication between controllers.) Enter the IP
address, netmask, and gateway for the Ether 1 interface. Use the IP address from
the
controller show console command for Controller 2.
• Primary DNS Server: Enter the IP address of the primary DNS.
• Secondary DNS Server: (Optional) Enter the IP address of a secondary DNS.
• Domain Name: (Optional) Enter the domain name for the controller.
2 Click Continue.
The Startup Wizard issues a warning that data and configuration information on the
controller to be joined will be lost and asks you to confirm.