Dell Compellent Series 30 - Manual (Page 40)

34 Storage Center System Setup Guide
Setting Up the Storage Center
Figure 29. Create iSCSI Fault Domain
3 (iSCSI only) Enter the IP Address of the Control Port for the new iSCSI fault domain.
Check your pre-installation documentation for this address.
4 (iSCSI only) Click Continue.
The Startup Wizard generates the new iSCSI fault domain and the initial port
configuration.
While the initial port configuration is being generated, the Startup Wizard displays a
window showing progress. After the configuration has been generated, it is
automatically validated. If the valid at on is successful, the confirmation window shown
in Figure 30 on page 35 appears. If there are warnings, they will appear in a similar
window with errors listed. See example in Figure 21 on page 27.